WELCOME!


It is hard to believe that it was almost ten years ago I witnessed a CNC router in action for the very first time. I was fascinated with what I saw and simply had to have one! Although I had been in the creative end of the three dimensional sign business for most of my life I didn't really know what I would do with one - but I just knew it could do fantastic stuff.

Through extensive research and LOTS of hands-on practice I quickly found out that my MultiCam router was capable of just about anything imaginable.This journal will chronicle that journey to date and continue each week with two or three entries as I continue to explore just what is possible with this wonderful tool... -dan

Friday, November 26, 2010

Horsing around

 I could see as the sign routed that this was going to look pretty special when it was assembled. The details looked great! I pulled the pieces off the router table this morning and dusted them off before I started gluing them up.

Gluing the pieces together only took minutes. I used PB Bond 240 from Coastal Enterprises which is a single component glue activated with a simple spritz of water. I used screws instead of clamps as the pieces were so irregular in shape. The screws will come out later and the holes filled as I begin the sculpting process. As I sculpt I'll diminish the thoroughbred look and add a little more of the nag feel we are after on this project.


I'll also add the woodgrain to the slat ends at that time. While I could have easily programed the woodgrain into the ends, the reality is that it is just as easy to do it by hand with a die grinder. From here on in it will be all about hand work.

-dan