WELCOME!


It is hard to believe that it was almost ten years ago I witnessed a CNC router in action for the very first time. I was fascinated with what I saw and simply had to have one! Although I had been in the creative end of the three dimensional sign business for most of my life I didn't really know what I would do with one - but I just knew it could do fantastic stuff.

Through extensive research and LOTS of hands-on practice I quickly found out that my MultiCam router was capable of just about anything imaginable.This journal will chronicle that journey to date and continue each week with two or three entries as I continue to explore just what is possible with this wonderful tool... -dan

Friday, July 22, 2016

First half of Viking ship done!

Today, we finished the first half of the Viking ship. After the painting was finished we carefully lifted the top section of the ship with the forklift and bolted the shipping frames to the bottom. These will prevent the ship from sliding in the container during transit. These ship pieces are now ready to crane into the container.



The detail throughout the piece is superb and the crew is justifiably proud. It's the biggest single piece we have built in the shop.



The view from the end of the ship shows how the keels will bolt on to secure the two halves together once it arrives on site in Dubai. The ships will sit in a pool about 30" deep. The galvanized mesh on the bottom is to allow the water to flow in and out of the bottom of the ship around the frame.